Starlux 1540 and Starlux 2940 Fractional Laser Skin Resurfacing

If you are interested in skin rejuvenation you will be hearing a lot about Starlux, Fraxel Repair and Fractional Skin Rejuvenation in the future. To better understand the significance of these new advances some technical knowledge of cosmetic laser skin treatments for cosmetic laser skin rejuvenation and past laser skin care technology is important.

before and after CO2 laser skin resurfacing for wrinkle removal and skin rejuvenation

The photo above shows the result of a full face CO2 Laser Resurfacing for wrinkle removal done 10 years ago using the Ultrapulse CO2 laser, a revolutionary advance in 1995. While the wrinkle removal results were stunning, CO2 laser resurfacing created a “burn wound” that took months of recovery and after a year often left the skin white or hypo pigmented. Because of the prolonged recovery, the need for general anesthesia, and other side effects most people today do not choose to have this effective wrinkle removing procedure.

Over the past three years the concept of Fractional Skin Rejuvenation or Fractional Laser Skin Resurfacing has evolved. With Starlux Fractional Skin Rejuvenation the laser beam, an erbium laser beam, is broken up or fractionated into many small micro beams which are separated so that when they strike the skin surface small areas of the skin between the beams are not hit by the laser and left intact. (See Figure Below.)

The small areas treated by the Starlux and Fraxel fractional micro beams, called micro treatment zones, cause sufficient laser injury to promote new collagen production to replace collagen damaged by aging and sun exposure. The new collagen produced by the laser injury “plumps” skin wrinkles. The intact skin between the micro treatment zones allows for much more rapid healing-3-4 days as opposed to 2-3 weeks for the older CO2, and enough pigment cells are left intact that hypo pigmentation does not occur.

starlux fractional laser skin resurfacing diagram

The diagram above shows the progression of laser skin rejuvenation technology from the older CO2 on the left to the newest Starlux fractional ablative lasers which have just been released. The Fraxel laser and the Starlux 1540 are depicted in the 3rd illustration under Non ablative fractional laser resurfacing.

Starlux Fractional Non Ablative Laser Resurfacing

To ablate means to “surgically remove”. The Fraxel and Starlux1540 are non ablative lasers which mean that when the laser beam strikes the skin the skin is not removed immediately, rather the laser beam heats the skin to cause inflammation and new collagen production. The benefits of the Starlux 1540 non ablative laser skin treatments are dramatically reduced recovery time, but the results in terms of wrinkle removal and skin tightening are less dramatic than with ablative lasers.

However, the new Starlux 1540 fractional lasers are able to penetrate much deeper than traditional non fractional ablative lasers and we are discovering that deeper penetration of the laser produces a much more dramatic stimulation of new collagen formation which translates into a plumping effect on the skin. This is particularly useful in treating depressed acne scars.

Another diagram which helps explain the Starlux 1540 effect is the microscopic section of skin that has been treated with the Starlux fractional laser below.

Before and after Starlux 1540 fractional laser skin resurfacing

In summary, the benefits of Starlux fractional non ablative laser skin treatments are:

  1. Less down time- only pink skin for 1-2 days and a day or so of bronzing that can be covered with make up
  2. Better new collagen production in the deeper skin layers causing skin plumping especially of acne scars
  3. Fewer complications like hyper pigmentation (although with Fraxel there is a 15% incidence of hyper pigmentation (darkening of treated areas) especially in dark skinned people, but it is temporary.
  4. Improvement in skin texture and possibly enlarged pores
  5. Improvement in wrinkles (See Photos below of Lux 1540 Results)

before picture of Starlux 1540 fractional laser skin resurfacingafter picture of Starlux 1540 fractional laser skin resurfacing

Above-Before and after Starlux 1540 non-ablative fractional laser skin resurfacing, treatment-Photos courtesy of Palomar and Dr Dwight Scarborough

The Future-Starlux Fractional Ablative Laser Resurfacing

Recently several new fractional ablative lasers have been developed which have the benefits of fractional treatments, less down time and complications, as well as the benefits of ablative skin resurfacing, better wrinkle removal and facial rejuvenation. The Starlux fractional ablative lasers are depicted in the last or 4th picture in the first comparative fractional laser diagram above.

The fractional ablative lasers remove the tissue in the micro treatment zone rather than just heating it as is done with Fraxel and the Starlux 1540.

The benefit of ablation is that more sun damaged, wrinkled skin is removed than with the Starlux 1540 or Fraxel, and better wrinkle removal and skin surface smoothing and textural improvement is achieved. This however comes at the price of some recovery time, redness and pinkness for 4-6 days. The Starlux fractional ablative lasers however require much less recovery time than the traditional non fractional erbium and CO2 ablative lasers which required weeks of recovery. Reliant, the company that makes Fraxel has released a new CO2 fractional laser called the Repair, Lumenis has released a CO2 fractional ablative laser called ActiveFX and DeepFx for Bridge Therapy, and Palomar has released the Starlux 2940, an Erbium fractional ablative skin resurfacing laser.

Impressive wrinkle removal and improvement in skin texture is achieved with the Starlux 2940 fractional ablative laser (see Photos of my patients Below).



before and after picture of starlux 2940 fractional ablative erbium laser skin resurfacingAbove: Before and after Starlux 2940 fractional laser skin resurfacing.

Before and After Photo Combined Laser Resurfacing for Facial Rejuvenation

Before and After Photo Combined Laser Resurfacing

Above: Before and after Starlux 1540 and 2940 combined fractional laser skin resurfacing.

Before and After Combined Fractional Laser Resurfacing

Before and After Combined Fractional Laser Resurfacing

Above: Before and after Starlux 1540 and 2940 combined fractional laser skin resurfacing.

The first non ablative fractional laser on the market was the Fraxel. The Starlux 1540 and 2940 are newer and improved fractional laser skin resurfacing technology.

The field of laser skin rejuvenation is advancing rapidly and new technological breakthroughs occur frequently. The benefit to you is that better wrinkle removal results are possible with less down time and fewer potential side effects.

The applications of fractional laser technology are expanding to other fields like skin tightening and eventually to fat and cellulite removal.

For further information on the Starlux fractional erbium laser skin resurfacing laser for skin rejuvenation and facial aging read Save Your Face or contact me. In my practice I use the new Starlux 1540 Fractional Non ablative erbium laser and the Starlux 2940 ablative fractional laser for skin rejuvenation.

Be sure to sign up fro my free email newsletter to keep up on new developments.

Dr Seckel

Concord, Massachusetts

Boston, Massachusetts

Information and Links

Join the fray by commenting, tracking what others have to say, or linking to it from your blog.

Other Posts

Reader Comments

Sorry, comments are closed.

Warning: fsockopen() [function.fsockopen]: php_network_getaddresses: getaddrinfo failed: Name or service not known in /home/salembiz/public_html/drseckel/wp-content/plugins/wp-shortstat.php on line 124

Warning: fsockopen() [function.fsockopen]: unable to connect to udp:// (php_network_getaddresses: getaddrinfo failed: Name or service not known) in /home/salembiz/public_html/drseckel/wp-content/plugins/wp-shortstat.php on line 124

Warning: stream_set_timeout() expects parameter 1 to be resource, boolean given in /home/salembiz/public_html/drseckel/wp-content/plugins/wp-shortstat.php on line 125